Slide Bridge Connector SPT1 - Green - Pack of 25

This Slide Bridge Connector can splice 2 pieces of 18 gauge SPT1 wire together, creating a seamless transition between two pieces of zip wire.

Easy Step by Step-Plug Installation

1. Locate the "ribbed" side of wire #1. The ribbed side of the wire connects to the larger blade which is most often on the right side of the plug.
2. Place the wire as far down into the vertical channel as it will go. The ribbed side of the wire should go on the same side as the larger blade's connection pin.
3. Slide the back onto the plug. This allows the two contact points to penetrate the wire's insulation.
4. Repeat the steps for wire #2.
5. The slide bridge is now complete and ready to use!